English |
21
Bosch Power Tools
2 609 004 157 | (11.5.10)
Assembly
Battery Charging
f
Use only the battery chargers listed on the
accessories page.
Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Note:
The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A long
battery service life is achieved in this manner.
Removing the Battery
To remove the battery
2
, press the unlocking
buttons
1
and pull the battery out of the ma-
chine to the rear.
Do not exert any force.
Battery Charge-control Indication
When the power tool is switched on, the battery
charge-control indicator
4
signals the still avail-
able battery capacity or an overload.
When the battery charge-control indicator
4
flashes
red
, the machine is subject to overload.
Please observe the information in section “Tem-
perature-dependent Overload Protection”,
page 25.
Changing the Tool
f
Before any work on the machine itself (e.g.
maintenance, tool change, etc.) as well as
during transport and storage, remove the
battery from the power tool.
There is danger
of injury when unintentionally actuating the
On/Off switch.
f
Wear protective gloves when changing ap-
plication tools/accessories.
Contact with
the application tool/accessoriy can lead to
injuries.
Selecting the Application Tool/Accessory
The following table shows examples for application tools. Further application tools can be found in
the extensive Bosch accessories program.
Indication
Capacity
Continuous lighting, green
>70 %
Continuous lighting, yellow
30–70 %
Continuous lighting, red
<30 %
Accessory
Material
Application
BIM segment
saw blade
Wooden materials,
plastic, non-ferrous
metals
Separating and plunge cuts; also for sawing
close to edges, in corners and hard to reach
areas;
Example: shortening already installed bottom
rails or door hinges, plunge cuts for adjusting
floor panels
Base plate for
sanding, se-
ries Delta
93 mm
Depends on sand-
ing sheet
Sanding surfaces close to edges, in corners
or hard to reach areas;
Depending on the sanding sheet for, e.g.,
sanding wood, paint, varnish, stone
HCS plunge
cut saw blade,
wood
Wooden materials,
soft plastics
Separating and deep plunge cuts; also for
sawing close to edges, in corners and hard to
reach areas;
Example: narrow plunge cut in solid wood for
installing a ventilation grid
OBJ_BUCH-1170-002.book Page 21 Tuesday, May 11, 2010 3:36 PM
