3
Note: To avoid jeopardising the electrical safety of the
appliance, it is forbidden to use high-pressure or steam jet
cleaning devices.
SHOULD THE RELEVANT CONDITIONS NOT BE PROPERLY
SATISFIED, THE INSTALLER, AND NOT THE
MANUFACTURER, SHALL BE HELD LIABLE.
Installation
Statutory requirements
This installation must conform with the following:
■
Manufacturer’s Installation instructions
■
Local Gas Fitting Regulations
■
Municipal Building Codes
■
Refer to AS/NZS 5601.1 for Gas Installations
■
S.A.A. Wiring Code
■
Local Electrical Regulations
■
Any other statutory regulations
Preparing to install
Refer to AS/NZS 5601.1 for piping size details. These built-in
cooktops are intended to be inserted in a benchtop cutout.
Only an officially authorised technician should connect the
appliance.
Before you begin, turn off the gas and electricity supply.
Before connecting the unit, check whether the local connection
conditions (type of gas) are compatible with the unit’s setting.
Observe any special conditions imposed by local suppliers
(utilities). The specifications of this cooktop are stated on the
data label located on the bottom of the cooktop base.
A duplicate data label is supplied for adhesion to an accessible
location near the hotplate if the data label on the base of the
hotplate cannot be accessed when the hotplate is installed.
