36
en | (Optional) Installing the Illuminator
MIC IP ultra 7100i
│
MIC IP starlight 7100i
2019-07-03 | 0.17 |
Installation Manual
Bosch Security Systems
11
(Optional) Installing the Illuminator
Use the correct set of tools as well as the recommended torque values given in the
instructions that follow. The use of the wrong tools or torque values may cause damage to
threads or seal caps, which may result in leaks or damage to paint, which then may lead to the
start of corrosion.
Parts List
Additional Tools Required
Notice!
This product has been tested according to standard IEC62471:2006 “Photobiological safety
of lamps and lamp systems”. The product emissions exceed the EXEMPT Group limit for both
Retinal Blue Light and Cornea/Lens infrared hazard as defined by IEC 62471:2006. The
product was found to meet the Risk Group 1 exposure limits for IR and White LEDs.
Refer to the MIC7000 Operation Manual for complete information on illumination safety.
Notice!
If the MIC camera will have both illuminator and sunshield accessories, install the illuminator
first.
If the camera will be mounted inverted, you must rotate the tilt head before attaching the
illuminator.
1.
Apply power.
2.
Connect to your network.
3.
From the web browser, access the camera’s Configuration page. Select Camera >
Installer Menu > Orientation.
4.
Select “Inverted”. Click
Set
to confirm the selection. The camera head will rotate
automatically into inverted position (180°).
Regardless of mounting orientation, the visor should always be above the camera window.
Apply power and connect to your network as illustrated in the figure below.
From the web browser, access the camera’s Settings page. Select Advanced > Camera >
Installer Menu > Orientation, and then select “Inverted”. Click
Set
to confirm the selection.
The camera head will rotate automatically into inverted position (180°).
Regardless of mounting orientation, the visor should always be above the camera window.
Bosch suggests storing the access plug inside the DCA mount (or wall mount accessory) in
case it becomes necessary to remove the illuminator.
–
Using the T20 Torx driver, tighten the screws to the proper torque using the sequence
described in the previous figure.
Summary of Contents for MIC IP ultra 7100i
Page 1: ...MIC IP ultra 7100i MIC IP starlight 7100i MIC 7504 MIC 7522 en Installation Manual ...
Page 2: ......
Page 55: ......
