Bosch MIC IP ultra 7100i, Installation Manual

Page: 22 / 56

22 en | Mounting MIC IP ultra 7100i
│
MIC IP starlight 7100i
2019-07-03 | 0.17 | Installation Manual Bosch Security Systems
Corner Mount
MIC-CMB-BD,
-WD, -MG
MIC-SCA-BD,
-WD, -MG
MIC-WMB-BD,
-WD, -MG
Figure 5.4: Typical Corner mount configuration
Note: Always install an SCA when you install a wall mount for any installation configuration.
Route cables through the bottom of the SCA (to prevent water from running into the side or
top of the SCA along the cables).
Surface Mount
5.4 Considerations for Mounting the Camera in Inverted
Orientation
To change the camera orientation to “Inverted,” complete the following steps:
1.
Remove the camera from the shipping box.
2. Apply power to the camera.
3. Access the web browser of the camera.
4. Access the page Configuration.
5. Navigate to Camera > Installer Menu > Orientation.
6. Select “Inverted.”
The camera head will rotate automatically into inverted position (180°).
Note the position of the visor when the camera is installed in inverted orientation. The visor
will now be near the body of the camera.
Figure 5.5: MIC camera with camera head inverted
Note: It is not necessary to remove the section for the illuminator on the sunshield because
the illuminator is attached to the opposite side of the camera visor.
Seal the mount so that moisture or water cannot collect and stay in the bottom of the MIC
camera.