2. Remove the two (2) screws at the bottom of one yoke arm using a wrench (user-supplied)
as described below.
Notice!
At the end of 2014, the 4 screws that attach the yoke arms to the base of the camera were
changed from Torx head screws to 5 mm Hex head screws. Both head types accommodate a
T30 Torx bit.
Be sure to note which screw head type is on your MIC 7000 camera since there are different
torque requirements as shown in Torque requirements for yoke arm screws, page 25.
Figure 11.3: Remove screws from yoke arms
Notice!
Risk of damage to the device.
Carefully support the head of the camera while completing the next four (4) steps.
3. Put the screws in a safe place. You will reinstall the screws at step 6.
4. Repeat steps 2 and 3 for the second yoke arm.
MIC IP starlight 7000 HD, MIC IP
dynamic 7000 HD
Cant the Camera | en
23
Bosch Security Systems
Installation Manual
2015.12 | 3.0 | F.01U.291.520
Summary of Contents for MIC-71xx
Page 1: ...MIC IP starlight 7000 HD MIC IP dynamic 7000 HD MIC 71xx MIC 72xx en Installation Manual ...
Page 2: ......
Page 35: ......
