Bosch Lave-Vaisselle, Operating Instructions Manual

Page: 24 / 60

22
Dishes are
not getting
clean enough 1. Spray arm movement obstructed.
2. Spray arm nozzles clogged.
3. Improper use of detergents.
4. Filters could be clogged.
5. Dishes are nested or loaded too
close together.
6. Selected wash cycle is not suitable
for food soil conditions. 1. Ensure that spray arm movement is
not blocked by hand rotating spray arms
before starting cycle.
2. Remove the spray arms and clean
according to the “Care and Mainte-
nance” section of the manual.
3. Increase or decrease detergent
depending on the water hardness
(refer to Table 1).
4. Clean the filters according to the
“Care and Maintenance” section of the
manual.
5. Rearrange load such that water
spray can reach all items in the dish-
washer - see “Loading the Dishwasher”
section of the manual.
6. Refer to “Wash Cycle Information” sec-
tion of the manual.
Streaks on
glassware or
residue on
the dishes 1. Incorrect rinse aid setting. 1. Depending on the hardness of
water, adjust the rinse aid dispenser.
Refer to “Adding Detergent and
Rinse Aid” section of the manual.
Odor
Note: Water
testing is
done in the
factory. Occa-
sionally water
may still
appear in
dishwasher at
purchase
which may
create an
odor.
1. Food debris is present at the bot-
tom of the dishwasher.
2. Food particles are present near
the door seal.
3. Dishes left in unit too long before
running a cycle.
4. Residual water is present at the bot-
tom of the dishwasher.
5. Drain hose is obstructed. 1. Remove the filters and clean accord-
ing to the “Care and Maintenance” sec-
tion of the manual.
2. Refer to “Care and Maintenance” sec-
tion of the manual.
3. Run a Rinse cycle if you do not
intend to immediately wash the dishes
4. Ensure the unit has completely
drained from the last cycle.
5. Remove any obstructions from the
drain hose by calling qualified personnel.
Note: If odor still persists, run the Nor-
mal/Regular cycle until it flushes and
interrupt the cycle and place an 8 oz.
cup of distilled white vinegar solution on
the upper rack and then finish the cycle.
Dishwasher
not filling
with water or
“Check water
supply” dis-
play lights up 1. Restriction in the water supply
system.
2. Previous wash cycle was not com-
pleted.
3. Delay start is active.
4. Household water supply turned
off. 1. Ensure that the water supply valve
(typically located under kitchen sink)
is open and check that the water sup-
ply line has no kinks or clogs.
2. Refer to the “Operating the Dish-
washer” section of the manual.
3. Cancel the delay start or wait until
delay start time completes.
4. Turn on water supply.
Fascia panel
discolored
or marked 1. Abrasive cleaner used. 1. Use mild detergents with soft
damp cloth.
Problem Cause Action