Bosch Lave-Vaisselle, Operating Instructions Manual

Page: 19 / 60

17
Cycle Completion Signal
1 Open the door and press the [On/Off] button.
2 Hold down the “ A ” button (see page 17) and press [Start] until the
display indicates “
d:00
”. Release both buttons.
3 Press the “
A
” button until the display shows “
b:02
”.
4 Press the “ C ” button to increase or decrease the tone “ b:00 ” = OFF
and “ b:03 ” = LOUDEST and press [Start] to save setting and close the
door.
Setting the Amount of Rinse Aid Used
The amount of rinse aid dispensed can be set from “r:00” to “r:06”.
1
Open the door and press the
[On/Off]
button.
2 Hold down the “
A
” button (see page 17) and press
[Start]
until the
display indicates “ d:00 ”. Release both buttons.
3 Press the “ A ” button until the display shows “ r:05 ”.
4 Press the “
C
” button to select the desired setting.
“
r:00
” = dispenser is OFF
“
r:01
” = lowest setting
“ r:02 ” = low setting
“ r:03 ” = medium setting
“
r:04
” = medium/high setting
“
r:05
” = high setting
“ r:06 ” = highest setting
5 Press [Start] to save the setting and close the door.
Note: Using rinse aid and setting the dispenser to “r:00” may result in longer cy-
cle times
.
Auto Power Off
To save energy, the dishwasher is turned off 1 minute after the wash
cycle ends. This setting can be adjusted from P:00 to P:02.
To change the setting:
1
Open the door and press the [On/Off] button.
2 Hold down the “A” button (see page 17)and press [Start] until the
display indicates
“d:0x”
(x can be any number). Release both but-
tons.
3 Press the “A” button until the display indicates “P:0x” .
4 Press the “C” button until the display corresponds with your require-
ments.
P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02
= dishwasher turns off automatically after 120 minutes (2 hours)
5
Press
[Start]
to save the setting
.