Bosch INDEGO 350, Installation Manual, Page: 9 / 67

!
A
C
B
B
C
A
4
Perimeter wire layout
… peg the wire down using
the same peg used at step 4.5.
▶ A: Cut the wire and strip 10–15 mm of insulation off.
▶ B: Connect it to the left hand (red) terminal.
▶ C: Clip over the backing cover.
After a few weeks, the wire will disappear under the grass.
Approximately 20 cm of lawn around the fixed object and
around the edge of the lawn will not be mown. For safety
reasons blades cannot reach up to the edge of the mower.
Lay the perimeter wire around the lawn area
and objects (4.9). Start from the docking station in an anti-clockwise direction.
This is important so your Indego cuts inside that area.
Use a mallet to insert the pegs in the ground (holding the wire in place)
and the 75 cm ruler provided to maintain the distance between them.
Marking permanent objects
that are at least 75 cm from
the perimeter wire (1.2).
Mark out permanent objects you do not want
the mower to run over, e.g. roots, ponds, rocks.
This will prevent your Indego colliding with
objects, or going straight into them.
▶ A: Run the wire from the lawn perimeter
to the object.
▶ B: Continue round the object in a
clockwise direction. When going
around the object use more pegs,
so they are closer than 75 cm.
▶ C: Return the wire back to the perimeter.
Ensure the distance from the wire
around the object and lawn perimeter
is at least 75 cm.
Place the perimeter wire under the same side
of the peg. Make sure it does not cross.
Remember to leave 30 cm around the object
to the wire!
If objects are less than 75 cm from the lawn
edge, surround the object when installing the
wire, leaving the object outside of the lawn
cutting area.
Make sure that the two parallel wires to
and from the marked object are as close as
possible. This will make the wire undetectable
to your Indego.
Check from time to time the wire does not
become loose, attach the wire to the ground
with additional pegs if it does.
4.8
4.9
4.10
When the perimeter wire has been
laid around the entire cutting area
(including objects like trees, ponds,
flower beds, etc.) …
Ensure:
▶ There is no loose wire as it
could be cut during mowing.
▶ The wire is flat to the
ground all the way.
Use additional pegs where
the wire is slack.
▶ The wire is taut before
placing the next peg (if you
can place a couple of fingers
under the wire this is not
taut enough!).
▶ Increase the number
of pegs at a corner.
30 cm
75 cm
5 cm
~30 cm
<75 cm 0 cm
30 cm
75 cm
GB
17 16