Installation instructions
en
45
Fit regulator (NG) to the R1/2 connection as per figure.
Pressure test point
Direction of gas flow is indicated on the rear of the reg-
ulator. Use pipe compound or thread sealant, properly
threaded pipes and careful assembly procedure so that
there is no cross threading, etc., which might cause
damage or leakage. Make sure tahat all connections
performd are free of leakage.
WARNING TO THE INSTALLER
INSTALLATION WITH A HOSE ASSEMBLY
Only install with a hose assembly that complies with
AS/NZS 1869 (AGA Approved), 10 mm ID, class B or
D, no more than 1.2 m long and in accordance with
AS5601. Ensure that the hose does not contact the hot
surfaces of the hotplate or an oven, dishwasher ore
other appliance that may be installed next to the
cooker.
WARNING!
Ensure that the hose assembly is restrained from acci-
dental contact with the flue or flue outlet of an under-
bench oven.
The hose should not to be subjected to abrasion, kink-
ing or permanent deformation and should be able to
be inspected along its entire lenght. Unions compatible
with the hose fittings must be used and connections
tested for gas leaks.
Before Leaving- Check all connections for gas leaks
with soap and water DO NOT use naked flame for de-
tecting leaks. Ignite all burners both individually and
seperately to ensure correct operation of gas valves,
burners and ignition. Turn gas taps to low flame posi-
tion and observe stability of the flame for each burner
individually and all together. When satisfied with the
hotplate, please instruct the user on the correct method
of operation. In case the appliance fails to operate cor-
rectly after all checks have been carried out, refer to
the authorised service provider in our area.
It should be expressly noted that that we can not ac-
cept any liability for direct of indirect damage caused
by wrong connection, leakageor improper installation.
When being repaired, the appliance must always be
disconnected from the mains supply; if required, notify
our customer service.
Approved connections
These instructions apply only when the appliance is set
up in countries that are indicated on the rating plate.
If the appliance is set up, connected and used in a
country that is not indicated on the rating plate, installa-
tion and assembly instructions must be used that con-
tain data and information on the valid connection con-
ditions in the relevant country.
Caution!
Gas connection:
Never connect the appliance outlet directly to the gas
pipe. Always use the connecting pieces that are sup-
plied with the appliance.
Type of connection
ISO 7-1
Country
ISO 7-1
AU
Australia
X
NZ
New Zealand
X
Connection for natural gas (NG)
With natural gas (NG), the gas connection is made via
a gas tube or a flexible security tube equipped with a
screw thread at both ends.
Connection in accordance with ISO 7-1
Note:
Observe the country-specific requirements.
1.
Insert the new seal into the connecting piece. The
seal must sit correctly.
2.
Attach the connecting piece
(with a size 24 key)
to
the end of the gas connection (with a size 22 key).
3.
Attach the threaded connection on the gas pipe or
the safety hose (with a size 24 key) to the connect-
ing piece using a new seal and tighten this.
Summary of Contents for HXU09AH50A
Page 51: ......
