en
Trouble shooting
32
Upper glass cover
Before opening the top cover, remove any spills with a
cloth.
Use glass cleaner if possible.
For cleaning, remove the top cover. To do this, hold the
cover securely on both sides with both hands and pull it
upwards.
If the cover hinges become loose, note the letters
marked on them. The hinge with the letter R must be
fitted on the right, and the hinge with the letter L must
be fitted on the left.
After cleaning, re-assemble the top cover following the
same procedure in reverse order.
Only close the top cover once the burners have cooled
down.
Caution!
When using appliances that have a glass cover with
LED lighting
Do not use any of the following to clean the glass
cover
■
Undiluted cleaning agents
■
Abrasive cleaners or cleaning agents with a high
alcohol content
■
Aggressive cleaning agents, such as oven cleaner
or stain remover
■
High-pressure cleaners or steam jet cleaners
■
Harsh or scratchy cleaning agents
■
Hard scouring pads or cleaning sponges
The LED lighting and the hinges of the glass cover on
the hob must not come into contact with liquids.
Liquids will damage the printing, lighting and hinges on
the glass cover and prevent the LED lighting from
switching on.
3
Trouble shooting
Trouble shooting
If a fault occurs, there is often a simple explanation.
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Rectifying faults yourself
You can often easily rectify technical faults with the
appliance yourself.
If a dish does not turn out exactly as you wanted, you
can find useful cooking tips and instructions at the end
of this instruction manual.
--------
:
Warning – Risk of injury!
Incorrect repairs are dangerous. Do not attempt to
repair the appliance yourself. Repairs must only be
carried out by one of our trained after-sales engineers. If
the appliance is defective, call the after-sales service.
Fault
Possible
cause
Notes/remedy
The appliance is
not working.
Defective cir-
cuit breaker.
Check the circuit breaker in the
fuse box.
Power failure Check whether the kitchen light
or other kitchen appliances are
working.
The time is flash-
ing on the display.
Power failure. Reset the time.
The settings on
the appliance
cannot be config-
ured. A key sym-
bol has lit up on
the display or
†‘”“
.
The child-
proof lock is
activated.
Deactivate the childproof lock by
pressing and holding the button
with the key symbol for approx. 4
seconds.
’–
appears on
the display.
Cleaning rec-
ommenda-
tion.
Run the cleaning function in full.
The message can be dismissed
by pressing any button. It will con-
tinue to be displayed, however,
until the cleaning function has
been run in full.
The gas burner
does not ignite.
Power cut or
damp ignition
plugs.
Light the gas burner with a gas
lighter or a match.
The LED lighting
on the glass cover
is not working.
The LED light-
ing button
has not been
pressed.
Press the LED lighting button.
The glass
cover on the
appliance is
not fully open
or is closed.
Open the glass cover on the appli-
ance fully.
The glass
cover has not
been fitted
correctly.
Make sure that the hinges on the
glass cover have been fitted cor-
rectly; see the section entitled
"Glass cover".
Summary of Contents for HXS59II51N
Page 2: ......
