23
Water leaks
1. Suds
2. Door seal could be pulled away
from track
3. Condensation vent is blocked
4. Improper installation
1. Wrong type of detergent results in
suds and leaks - use only dishwasher
detergents. If suds still persist, add
one tablespoon of vegetable oil at
the bottom of the dishwasher and
run the desired cycle.
2. Ensure the door seal is in the track
3. Ensure that condensation vent is
not blocked
4. Have proper installation verified
by qualified personnel (water supply,
drain system, leveling, plumbing)
Tub stains
1. Stains on the dishwasher interior
are due to water hardness
2. Silverware in contact with tub
1. Concentrated lemon juice can
reduce the build up of hard water
stains. Run Normal cycle until it
flushes and interrupt the cycle and
then place an 8oz. cup of the con-
centrated lemon solution on the
upper rack and finish the cycle. This
can be done periodically to avoid
build up.
2. Ensure that silverware does not make
contact with the tub while running a cycle.
Detergent
dispenser
cover will
not shut
1. Improper operation of detergent
cover
2. Previous cycle has not been fin-
ished or cycle was interrupted
1. Refer to “Adding Detergent and
Rinse Aid” section of the manual for
instructions on opening and closing
the dispenser
2. Refer to the “Operating the Dish-
washer” section of the manual
Unable to
select
desired
cycle
1. Previous cycle has not finished
1. Refer to the “Operating the Dish-
washer” section of the manual
Touch sensi-
tive “but-
tons” not
activating
easily or
activating
without
being
touched
1. Water or other liquid on the sur-
face.
2. “Buttons” not being activated
properly.
1. Wiping the fascia may cause
unwanted activation. Dry clean when
possible. If you must use a damp
cloth to clean, dry immediately.
Never pour water on the controls.
2. Press the center of the “button”
with the flat area of your fingertip. A
beep will sound to indicate that the
selection has been made. Touching
the “buttons” lightly should work.
Note: There is a built in delay to pre-
vent someone from launching several
actions at once by accidentally wiping
their hand (or a cleaning cloth) across
the control panel.
Problem
Cause
Action
