Bosch HSB737357Z, Instruction Manual

Page: 7 / 28

Important safety information
en
7
:
Warning – Risk of electric shock!
■
Incorrect repairs are dangerous. Repairs
may only be carried out and damaged
power cables replaced by one of our
trained after-sales technicians. If the
appliance is defective, unplug the appliance
from the mains or switch off the circuit
breaker in the fuse box. Contact the after-
sales service.
Risk of electric shock and serious injury!
■
The cable insulation on electrical
appliances may melt when touching hot
parts of the appliance. Never bring
electrical appliance cables into contact with
hot parts of the appliance.
Risk of electric shock!
■
Do not use any high-pressure cleaners or
steam cleaners, which can result in an
electric shock.
Risk of electric shock!
■
A defective appliance may cause electric
shock. Never switch on a defective
appliance. Unplug the appliance from the
mains or switch off the circuit breaker in the
fuse box. Contact the after-sales service.
Risk of electric shock!
■
When replacing the cooking compartment
bulb, the bulb socket contacts are live.
Before replacing the bulb, unplug the
appliance from the mains or switch off the
circuit breaker in the fuse box.
:
Warning – Hazard due to magnetism!
Permanent magnets are used in the control
panel or in the control elements. They may
affect electronic implants, e.g. heart
pacemakers or insulin pumps. Wearers of
electronic implants must stay at least 10 cm
away from the control panel.
:
Warning – Burn-Back (Fire in burner tube
or chamber)!
In the event of a burn-back, where the flame
burns back to the jet, immediately turn off the
gas supply at the control valve on the panel.
After ensuring the flame is extinguished, re-
light the appliance in the normal manner.
Should the appliance again burn back, close
the control valve and call a service technician.
Do not use the appliance again until the
service technician has declared that it is safe
to do so.
:
Warning – Gas-pressure regulator!
This appliance requires an operating pressure
of 2,8 kPa at the appliance. A suitable LPG
regulator that complies with the requirements
of SANS 1237 must be installed.
:
Warning – Important Information for the
user!
This appliance may only be installed by a
registered LP Gas installer. All registered
installers are issued with a card carrying their
registration number. Ask to be shown the card
before allowing the installation work to
commence and make a note of the Installer
QCC number. Upon completion of the
installation, the installer is required to explain
the operational details of the appliance
together with the safety instructions. You will
be asked to sign acceptance of the installation
and be provided with a completion certificate.
You should only sign for acceptance of the
installation when the installation is completed
to your satisfaction.
Note that your invoice is required in the event
that you wish make a guarantee claim.
:
Warning – Important Information for the
installer!
This appliance may only be installed by a LP
gas installer registered with the Liquefied
Petroleum Gas Association of Southern Africa.
The appliance must be installed in accordance
with the requirements of SANS 10087-1 and
any fire department regulations and/or local
bylaws applicable to the area. If in doubt
check with the relevant authority before
undertaking the installation. Upon completion
of the installation you are required to fully
explain and demonstrate to the user the
operational details and safety practices
applicable to the appliance and the
installation.
:
Warning – Risk of overheating!
Covering the ventilation openings in the floor
of the appliance may cause it to overheat.
Always install the appliance on the feet
supplied.