Bosch HSB737357Z, Instruction Manual

Page: 20 / 28

en
Appliance door
20
Fitting the door panels
1.
Reinsert the inner panel.
Note:
All four fastening pins must engage in the
holders provided for them.
2.
Remove the locking pins and close the oven door.
Removing and fitting the appliance door
If the oven is very heavily soiled, the oven door can be
removed for easier cleaning. Normally, however, this is
not necessary.
Removing the appliance door
1.
Open the oven door fully.
2.
Lock both hinges on the left and right using the
locking pin
(a)
.
Note:
The locking pins must be fully inserted into the
holes in the hinges.
3.
Grip the oven door on either side with both hands
and close the oven door by approx. 30°
(b)
.
4.
Raise the oven door slightly and pull it out.
Note:
Do not fully close the oven door. The hinges
could become bent and the enamel could be
damaged.
Fitting the appliance door
1.
Grip the oven door on either side with both hands.
2.
Slide the hinges into the slots in the oven
(a).
Note:
The notch below the hinges must engage into
the frame of the oven
(b)
.
3.
Lower the door downwards.
4.
Remove the locking pins.
:
Warning – Risk of injury!
Do not reach into the hinge if the oven door falls out
unintentionally or a hinge snaps closed. Call after-sales
service.
:
Warning – Risk of injury!
The door may not close properly if the door hinges have
not engaged correctly. This will allow heat to escape
and the parts of the appliance may become very hot. To
prevent this from happening, remove the door again.
Then refit the door as shown in the drawing, making
sure that the groove on the underside of the hinges
engages in the oven frame.
D E
E D