en
Installation and connection
10
■
For safety reasons, this appliance must only be
connected to an earthed connection. If the safety
earth terminal does not comply with regulations,
safety against electrical hazards is not guaranteed.
■
An all-pole isolating switch with a contact gap of at
least 3 mm must be present in the installation circuit.
This is not necessary if the appliance is connected
by a plug that is accessible to the user.
■
Electrical safety: The cooker corresponds to safety
class I and may only be used in conjunction with a
safety earth terminal.
■
You must use a H 05 W-F type cable or equivalent
for the appliance connection.
The mains voltage must correspond to the voltage
specified on the rating plate.
Caution!
All appliances with a three-wire cable must be
earthed.
Connect the wires in the power cord according to the
colour coding:
Note:
If the power cord is replaced
Only connect it to the appliance as shown in the
connection diagram.
Levelling the cooker
Always place the cooker directly on the floor.
The cooker has height-adjustable feet. This allows you
to raise the plinth by about 15 mm. Please observe the
special installation instructions.
Adjacent units
Any adjacent units must not be made of flammable
materials. The fronts of any adjacent units must be heat-
resistant up to at least 90 °C.
Wall fixing
To prevent the cooker from tipping over, you must fix it
to the wall using the enclosed bracket. Please observe
the installation instructions for fixing the oven to the
wall.
Measures to be noted during transport
Secure all mobile parts in and on the appliance using
an adhesive tape that can be removed without leaving
any traces. Push all accessories (e.g. baking tray) into
the corresponding slots with cardboard at the edges, in
order to avoid damaging the appliance. Place
cardboard or similar between the front and rear side to
prevent knocks against the inside of the glass door.
Secure the door and, if available, the top cover to the
appliance sides using adhesive tape.
Keep the original appliance packaging. Only transport
the appliance in the original packaging. Observe the
transport arrows on the packaging.
If the original packaging is no longer available
pack the appliance in protective packaging to
guarantee sufficient protection against any transport
damage.
Transport the appliance in an upright position. Do not
hold the appliance by the door handle or the
connections on the rear, as these could be damaged.
Do not place any heavy objects on the appliance.
Explanaions
Green and yellow
earth wire
<
Blue
(null) neutral wire
Brown
phase (external conductor)