Bosch HHF133B.0B, Instruction Manual

Page: 19 / 32

en Rails
18
p
Rails
Rails
With good care and cleaning, your appliance will retain
its appearance and remain fully functional for a long
time to come. This will tell you how to remove the
shelves and clean them.
Detaching and refitting the rails
The rails can be removed for cleaning. The oven must
have cooled down.
Detaching the rails
1.
Lift up the front of the rail
2.
and unhook it (figure A).
3.
Then pull the whole rail forward
4.
and remove it (Fig. B).
Clean the rails with cleaning agent and a sponge. For
stubborn deposits of dirt, use a brush.
Refitting the rails
1.
First insert the rail into the rear socket, press it to the
back slightly (figure A),
2.
and then hook it into the front socket (figure B).
The rails fit both the left and right sides. Ensure that, as
shown in figure B, levels 1 and 2 are below and levels
3, 4 and 5 are above.
q
Appliance door
Appliance door
With good care and cleaning, your appliance will retain
its appearance and remain fully functional for a long
time to come. This will tell you how to remove the
appliance door and clean it.
Detaching and attaching the oven door
For cleaning purposes and to remove the door panels,
you can detach the oven door.
The oven door hinges each have a locking lever. When
the locking levers are closed (figure A), the oven door
is secured in place. It cannot be detached. When the
locking levers are open in order to detach the oven
door (Fig. B), the hinges are locked. They cannot snap
shut.
:
Warning – Risk of injury!
Whenever the hinges are not locked, they snap shut
with great force. Ensure that the locking levers are
always fully closed or, when detaching the oven door,
fully open.
Detaching the door
1.
Open the oven door fully.
2.
Fold up the two locking levers on the left and right
(figure A).
3.
Close the oven door as far as the limit stop. With
both hands, grip the door on the left and right-hand
sides. Close the door a little further and pull it out
(figure B).
% $
%
$
% $
% $
Appliance door en
19
Attaching the door
Reattach the oven door in the reverse sequence to
removal.
1.
When attaching the oven door, ensure that both
hinges are inserted straight into the opening
(figure A).
2.
The notch on the hinge must engage on both sides
(figure B).
3.
Fold back both locking
levers (figure C). Close the oven door.
:
Warning – Risk of injury!
If the oven door falls out accidentally or a hinge snaps
shut, do not reach into the hinge. Call the after ­ sales
service.
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels
from the oven door.
Removal
1.
Detach the oven door and lay it on a cloth with the
handle facing down.
2.
Pull off the cover at the top of the oven door. Press
in the tabs on the left and right using your fingers
(fig. A).
3.
Lift the top panel up and pull it out (fig. B).
4.
Lift the panel up and pull it out (fig. C).
Clean the panels with glass cleaner and a soft cloth.
:
Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
Installation
During installation, make sure that the lettering "top
right" is upside down at the bottom left.
1.
Insert the panel at an angle towards the back
(fig. A).
2.
Insert the top panel at an angle towards the back
into the brackets. The smooth surface must face
outwards. (fig. B).
3.
Put the cover back in
place and press on it.
4.
Attach the oven door.
Do not use the oven again until the panels have been
correctly installed.
Additional door safety
When preparing meals with long cooking times, the
oven door can reach very high temperatures.
Supervise small children and keep them away from the
oven when the oven is in operation.
Additional safety devices have been fitted to prevent
contact with the oven door. Always attach these safety
devices when children could come near the oven.
You can purchase this optional accessory (11023590)
from the after-sales service.
% $
&
% $
&
%
$