-16-
Sanding Accessories
Assembly
BACKING PAD
Before
attaching
a
backing pad be sure its
maximum safe operating speed is not
exceeded by the nameplate speed of the
tool.
Wheel guard may not be
used for most sanding
operations.
Always reinstall wheel guard
when converting back to grinding operations.
Do not use the Quick-
Clamping
Nut
with
backing pad for sanding accessories.
TO INSTALL BACKING PAD AND
SANDING DISC (Not Included)
Disconnect battery pack from tool.
Attach hand shield. Set the tool on its top
side (spindle up). Place the rubber backing
pad onto the spindle shaft. Center the
sanding disc on top of the backing pad.
Insert the lock nut through the disc and
thread onto the spindle as far as you can
with your fingers. Press in the spindle lock,
then tighten the backing pad securely with
lock nut wrench (Fig. 6).
TO REMOVE: Reverse procedure.
WIRE CUP BRUSH ASSEMBLY
Disconnect tool from the power supply.
A t t a c h h a n d s h i e l d ( F i g . 1 ) . W i r e c u p
b r u s h e s a r e e q u i p p e d w i t h t h e i r o w n
threaded hub, simply thread on to spindle.
Be sure to seat against shoulder before
turning tool “ON”.
TO REMOVE: Reverse procedure.
WIRE WHEEL ASSEMBLY
Disconnect tool from the power supply.
Install type 27 guard (Fig. 7). Wire wheels
are equipped with their own threaded hub,
simply thread on to spindle. Be sure to seat
against shoulder before turning tool “ON”.
TO REMOVE: Reverse procedure.
SANDING
DISC
BACKING
PAD
(sold separately)
LOCK NUT
(sold separately)
WIRE CUP BRUSH
SPINDLE
FIG. 6
HAND SHIELD
(sold separately)
Assembly
SPINDLE
TYPE 27
WHEEL GUARD
WIRE WHEEL
FIG. 7
