-19-
Assembly
Inserting and Releasing
Battery Pack
T h i s t o o l i s e q u i p p e d w i t h A u t o m a t i c
R e s t a r t P r o t e c t i o n . T h i s f e a t u r e h e l p s
prevent accidental startups after power has
b e e n i n t e r r u p t e d , e . g . t h e b a t t e r y w a s
removed with the switch locked in the on
position. To resume operation, turn the side
switch to the off position, and back to on
position to restart the tool.
Make sure that the side switch (Fig. 13) is
i n t h e o f f p o s i t i o n b e f o r e i n s e r t i n g o r
removing battery pack. To insert the battery
pack slide it into the housing until the
battery pack locks into position.
Your tool is equipped with a secondary
locking latch to prevent the battery pack
from completely falling out of the handle,
should it become loose due to vibration.
T o r e m o v e t h e b a t t e r y p a c k , p r e s s t h e
battery pack release button and slide the
battery pack forward.
Press the battery pack release button again
and slide the battery pack completely out of
tool housing (Fig. 12).
FIG. 12
6. Screw in side handle to secure stability
bracket between the tool housing and
handle.
7. Adjust guard to desired depth of cut.
TO REMOVE: Reverse procedure.
INSTALLING DRY DIAMOND WHEEL
(Fig. 11)
1. Place the backing flange on the spindle.
Turn flange until it locks with the base of
the spindle.
2. Place the dry diamond wheel onto the
spindle and align the arbor hole of the
grinding wheel with the shoulder of the
backing flange.
3. Tighten lock nut with supplied lock nut
wrench while holding spindle lock.
TO REMOVE: Reverse procedure.
FIG. 11
SPINDLE
LOCK NUT
BACKING
FLANGE
DRY
DIAMOND
WHEEL
LOCK NUT
BACKING
FLANGE
SPINDLE
DRY
DIAMOND
WHEEL
