English - 2
The numbering of the machine elements refers to
the representation of the machine on the graph-
ics page.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
1 Thread for auxiliary handle (3x)
2 Spindle lock button
3 On/Off switch
4 Auxiliary handle
5 Grinder spindle
6 Protection guard
7 Adjustment screw
8 Clamping lever
9 Mounting flange with O-ring
10 Grinding/cutting disc*
11 Clamping nut
12
quick-clamping nut*
13 Clamping screw
14 Coded projection
15 Guard, grinding cup*
16 Grinding cup*
17 Two-pin spanner for clamping nut*
18 Hand guard*
19 Spacer discs*
20 Rubber sanding plate*
21 Sanding sheet*
22 Round nut*
23 Cup brush*
24 Diamond cutting disc*
25 Cutting guide with dust extraction
protection guard*
26 Handle unlocking button
27 Handle
28 Cutting grinder stand*
* Not all of the accessories illustrated or described are
included as standard delivery.
Working safely with this machine
is possible only when the operat-
ing and safety information are
read completely and the instruc-
tions contained therein are
strictly followed. In addition, the
general safety notes in the enclosed booklet
must be observed. Before using for the first
time, ask for a practical demonstration.
■
Wear protective glasses and hearing protec-
tion.
■
Wear additional protection equipment for your
safety, such as protective gloves, sturdy
shoes, hard hat and apron.
■
The dust that is produced while working can be
detrimental to health, inflammable or explo-
sive. Suitable safety measures are required.
Examples: Some dusts are regarded as carci-
nogenic. Use suitable dust/chip extraction and
wear a dust respirator.
■
Dust from light alloys can burn or explode. Al-
ways keep the workplace clean, as blends of
materials are particularly dangerous.
■
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
■
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Do not op-
erate the machine in rain or moisture.
■
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
■
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
■
Always direct the cable to the rear away from
the machine.
■
Always switch the machine off and wait until it
has come to a standstill before placing it down.
■
For power outage or when the mains plug is
pulled, unlock the On/Off switch immediately
and turn it to the off position. This prevents un-
controlled restarting.
■
The machine must be used only for dry
cutting/grinding.
■
For all work with the machine, the auxiliary
handle must be mounted.
Machine Elements
For Your Safety
1 609 929 R35.book Seite 2 Mittwoch, 13. Februar 2008 1:16 13
16 • 1 609 929 R35 • 03.11
