English - 3
■
Hold the power tool only by the insulated
gripping surfaces, when performing an op-
eration where the cutting tool may run into
hidden wiring or its own cord.
Contact with a “live” wire will make exposed
metal parts of the tool “live” and shock the op-
erator.
■
Use appropriate detectors to determine if
utility lines are hidden in the work area or
call the local utility company for assist-
ance.
Contact with electric lines can lead to fire and
electric shock. Damaging a gas line can lead
to explosion. Penetrating a water line causes
property damage or may cause an electric
shock.
■
For work with grinding or cutting discs, the pro-
tection guard 6 must be mounted. For work
with the rubber sanding plate 20 or with the
cup brush 23/disc brush/flap disc, the hand
guard 18 (accessory) is to be mounted.
■
Use dust extraction when working with stone.
The vacuum cleaner must be approved for ma-
sonry dust. When cutting stone, use the cutting
guide.
■
Do not work with materials containing asbes-
tos.
■
Use only grinding tools with a permissible
speed at least as high as the no-load speed of
the machine.
■
Check grinding tools before use. The grinding
tool must be properly mounted and turn freely.
Perform a test run for at least 30 seconds with-
out load. Do not use damaged, out-of-round or
vibrating grinding tools.
■
Protect the grinding tool from impact, shock
and grease.
■
Apply the machine to the workpiece only when
switched on.
■
Keep hands away from rotating grinding tools.
■
Pay attention to the direction of rotation. Al-
ways hold the machine so that sparks and
grinding dust fly away from the body.
■
When grinding metal, flying sparks are pro-
duced. Take care that no persons are endan-
gered. Due to danger of fire, no combustible
materials should be located in the vicinity
(spark flight zone).
■
Be careful when cutting grooves, e. g. in struc-
tural walls: See Information on Structures.
■
Blocking the cutting disc leads to jerking reac-
tion forces on the machine. In this case switch
off the machine immediately.
■
Pay attention to the dimensions of the grinding
disc. The mounting hole diameter must fit the
mounting flange 9 without play. Do not use re-
ducers or adapters.
■
Never use cutting discs for rough grinding. Do
not exert any lateral pressure on the cutting
discs.
■
Observe the manufacturer’s instructions for
mounting and using grinding tools.
■
Caution! The grinding tool runs on after the
machine is switched off.
■
Do not clamp the machine in a vice.
■
Never allow children to use the machine.
■
Bosch is only able to ensure perfect operation
of the machine if the original accessories in-
tended for it are used.
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting stone, a cutting guide is re-
quired.
Slots in structural walls are subject to the Stand-
ard DIN 1053, Part 1 or country-specific regula-
tions.
These regulations are to be observed under all
circumstances. Before beginning work, consult
the responsible structural engineer, architects or
the construction supervisor.
Intended Use
Information on Structures
1 609 929 R35.book Seite 3 Mittwoch, 13. Februar 2008 1:16 13
17 • 1 609 929 R35 • 03.11
