14
| English
1 609 929 K31 • 12.12.06
Noise/Vibration Information
Measured values determined according to
EN 60745.
Typically the A-weighted noise level of the machine is:
sound pressure level 94 dB(A); sound power level
105 dB(A). Uncertainty K=3 dB.
Wear hearing protection!
Overall vibrational values (vector sum of three direc-
tions) determined according to EN 60745:
For tightening screws and nuts of maximum permitted
size: Vibrational emission value a
h
= 4.3 m/s
2
, uncer-
tainty K = 0.5 m/s
2
.
The vibration emission level given in
this information sheet has been
measured in accordance with a standardised test
given in EN 60745 and may be used to compare one
tool with another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may
increase above the level given in this information
sheet. This could lead to a significant underestimate
of exposure when the tool is used regularly in such a
way.
Note:
To be accurate, an estimation of the level of
exposure to vibration experienced during a given
period of work should also take into account the times
when the tool is switched off and when it is running
but not actually doing the job. This may significantly
reduce the exposure level over the total working
period.
Technical Data
Declaration of Conformity
We declare under our sole responsibility that this
product is in conformity with the following standards
or standardization documents: EN 60745 according
to the provisions of the directives 89/336/EEC,
98/37/EC.
07.11.2006, Robert Bosch GmbH, Power Tools Division
D-70145 Leinfelden-Echterdingen
Assembly
Battery Charging (see figure A)
A battery that is new or has not been used for a longer
period does not develop its full capacity until after
approx. 5 charging/discharging cycles.
To remove the battery
4
press the unlocking buttons
3
and pull out the battery downwards.
Do not exert
any force.
The battery is equipped with a NTC temperature con-
trol which allows charging only within a temperature
range of between 0 °C and 45 °C. A long battery serv-
ice life is achieved in this manner.
A significantly reduced working period after charging
indicates that the battery is used and must be
replaced.
Observe the notes for disposal.
Changing the Tool (see figure B)
f
Before any work on the power tool, remove
the battery.
f
When working with an application tool, pay
attention that the application tool is firmly
seated on the tool holder.
When the applica-
tion tool is not firmly connected with the tool
holder, it can come loose again and not be control-
led.
Slide the application tool
7
onto the square drive of
the tool holder
1
.
Cordless Impact Screw-
driver
GDS 18 V-HT
PROFESSIONAL
Article number
3 601 J10 3..
Rated voltage
V=
18
No-load speed
rpm
0–1900
Impact rate
bpm
0–2100
Maximum torque, hard
screwdriving application
according to ISO 5393
Nm
475
Bolt size
M6–M20
Tool holder
½"
Weight according to
EPTA-Procedure
01/2003
kg
3.4
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.
WARNING
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
OBJ_BUCH-246-001.book Page 14 Tuesday, December 12, 2006 3:35 PM
