English |
19
Bosch Power Tools
1 609 92A 2HL | (23.1.17)
Cutting Off
– Firmly clamp the workpiece as appropriate for its dimen-
sions.
– Adjust the requested mitre and/or bevel angle.
– Switch on the machine.
– Press lever
22
and slowly guide the tool arm downward by
handle
4
.
– Saw through the workpiece applying uniform feed.
– Switch off the machine and wait until the saw blade has
come to a complete stop.
– Guide the tool arm slowly upward.
Sawing Workpieces of the Same Length (see figure O)
The material stop
27
can be used for easily sawing workpiec-
es to the same length.
The material stop can be mounted on either side of the saw ta-
ble extension
15
.
– Loosen lock screw
28
and swing the material stop
27
over
clamping screw
50
.
– Retighten lock screw
28
.
– Adjust the saw table extension
15
to the desired length
(see “Extending the Saw Table”, page 17).
Special Workpieces
When sawing curved or round workpieces, these must be es-
pecially secured against slipping. At the cutting line, no gap
may exist between workpiece, fence and saw table.
Provide for special fixtures, if required.
Replacing Insert Plates (see figure P)
The red insert plates
36
can become worn after prolonged
use of the machine.
Replace defective insert plates.
– Bring the power tool into the working position.
– Unscrew screws
51
with the provided hex key (4 mm)
17
and remove the old insert plates.
– Insert the new right-hand insert plate.
– Screw the insert plate with the screws
51
as far as possible
to the right, so that the saw blade does not come in contact
with the insert plate throughout the complete possible rip-
ping length.
– Repeat the work steps in the same manner for the left-hand
insert plate.
Sawing Profile Strips/Mouldings (Floor and Ceiling Strips)
Profile strips/mouldings can be sawn in two different ways:
– Placed against the fence
– Lying flat on the saw table.
Always make trial cuts with the mitre angle setting first on
scrap wood.
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings
Placed
against the
fence
Lying flat on
the saw table
Bevel angle
0°
45°
Floor strip/moulding
Left side
Right side
Left side
Right side
Inner corner
Horizontal mitre angle
45° left
45° right
0°
0°
Positioning of work-
piece
Bottom edge on
saw table
Bottom edge on
saw table
Upper edge against
the fence
Bottom edge
against the fence
The finished work-
piece is located ...
... to the left of the
cut
... to the right of the
cut
... to the left of the
cut
... to the left of the
cut
Outer corner
Horizontal mitre angle
45° right
45° left
0°
0°
Positioning of work-
piece
Bottom edge on
saw table
Bottom edge on
saw table
Bottom edge
against the fence
Upper edge against
the fence
The finished work-
piece is located ...
... to the left of the
cut
... to the right of the
cut
... to the right of the
cut
... to the right of the
cut
OBJ_BUCH-3086-002.book Page 19 Monday, January 23, 2017 12:48 PM
