FMR-7033
|
Installation Instructions | 6.0
Installing the FMR-7033 Instruction Label and Slide
.
Bosch Security Systems, Inc. | 9/08 | F01U010583-01
5
For battery standby calculations, assume that the
FMR-7033 draws 75 mA from the 24 VDC battery.
The FPD-7024 FACP uses a switching power supply to
convert 24 VDC battery power to 12 VDC option bus
power. This conversion reduces the current drawn
from the battery.
6.0 Installing the FMR-7033
Instruction Label and Slide
An instruction label is provided for placement on the
pullout slide. The slide can be installed to pull from the
left or right (slide it into rear of base).
Use care when installing the label. Place it
as close to the pull-tab as possible.
Figure 4:
Installing the Instruction Label and
Slide
Slide in either side
Back of FMR-7033 Keypad
Label
Label
Label
(writing on other side)
7.0 Setting the FMR-7033’s
Address
Each keypad must have its own address
set with its address pins. This address
must not conflict with the addresses of
other keypads or other option bus devices.
Each keypad address can support only one
device. All keypads must also be
programmed at the FACP.
Select the keypad address (1-15) by placing the
shorting jumpers over the address pins as shown in
Figure 5.
Figure 5:
FMR-7033 Keypad Addresses
1
2
4
8
1
2
4
8
1
2
4
8
1
2
4
8
1
2
4
8
Address 1
Address 4
Address 7
Address 10
Address 13
1
2
4
8
1
2
4
8
1
2
4
8
1
2
4
8
1
2
4
8
Address 2
Address 5
Address 8
Address 11
Address 14
1
2
4
8
1
2
4
8
1
2
4
8
1
2
4
8
1
2
4
8
Address 3
Address 6
Address 9
Address 12
Address 15
8.0 Programming the
FMR-7033
The control panel does not recognize the keypad until
the option bus is updated.
To update the option bus from the local keypad:
1.
Enter programming mode using the correct
programming code.
2.
Select menu item 3 – System.
3.
Select menu item 4 – Option Bus
4.
Select menu item 1 – Update Bus
5.
Press */back to exit from programming mode.
Ensure that the number of devices found
on the bus agrees with the number
installed.
9.0 Troubleshooting the
FMR-7033
Refer to
Table 2
on page 6 when troubleshooting
problems with the FMR-7033.
