PI - 34.85
Product Information Linear Smoke Detector Fireray 50/100RV
601-F.01U.002.705
A1.en / 29.12.2004
ST-FIR/ PRM1/ zab
Seite 12 von 22
7.2. Mounting the Fireray 50/100RV
To make mounting easier, you can remove the detector cover by gently raising the
upper and lower edges.
The mounting slots (see Fig. 3.), which are positioned at a 90
angle, enable vertical
or horizontal mounting of the detector.
Locate the four bore holes at the mounting location using the detector base plate.
Observe the planning notes and mounting tips!
Check the plug connector and the DIP switch settings (see Section 7.1.).
Secure the detector using four screws.
Refit the detector cover.
If a key switch is required, a two - wire cable should be routed from the
detector within reach during installation (see Section 7.4. for connection
details).
7.3. Mounting the prism reflector
Select the mounting location in line with the mounting tips (Section 7.).
A prism reflector must be used for the Fireray 50RV, and four prism reflectors
arranged in a square for the Fireray 100RV.
Fireray 50RV
Fireray 100RV
ÌÌÌÌÌ
ÌÌÌÌÌ
ÌÌÌÌÌ
ÌÌÌÌÌ
ÌÌÌÌ
ÌÌÌÌ
ÌÌÌÌ
ÌÌÌÌ
ÌÌÌÌÌ
ÌÌÌÌÌ
ÌÌÌÌÌ
ÌÌÌÌÌ
ÌÌÌÌ
ÌÌÌÌ
ÌÌÌÌ
ÌÌÌÌ
ÌÌÌÌ
ÌÌÌÌÌ
ÌÌÌÌÌ
ÌÌÌÌÌ
ÌÌÌÌÌ
ÌÌÌÌÌ
Fig. 4.: Prism reflectors
Each reflector is secured using two mounting bores. Arrange the four reflectors for
the Fireray 100RV such that there are no mounting holes in the center (see Fig. 4.).
There must be a free visual line between the detector and
reflector. The IR light beam must not be blocked by moved
objects!
