Installation instructions
en
17
¡
The width of the extractor hood must correspond at
least with the width of the hob.
¡
To optimally detect the cooking vapours, install the
appliance behind the hob.
¡
In order to freely access the fan box for servicing,
select an easy-to-reach installation site.
¡
The surfaces of the appliance are sensitive. Avoid
damaging them during installation.
15.8 Installation
Checking the units
▶
Check whether the fitted unit is level and has suffi-
cient load-bearing capacity.
The max. weight of the appliance is 40 kg.
Preparing the units
Note:
To install the hob and the appliance seamlessly,
you require special accessories, which are not included
in the scope of delivery. Observe the enclosed installa-
tion instructions for special accessories.
Requirement:
The unit is suitable for the installation.
1.
Make a cut-out in the worktop, depending on the in-
stallation position.
The angle between the cut surface and the worktop
must be 90°.
2.
Ensure that the worktop has sufficient load-bearing
capacity and stability.
Use a heat- and humidity-resistant reinforcing mater-
ial for any substructure.
3.
Ensure that the fitted unit is still stable after the cut-
outs have been made.
4.
Remove any shavings.
5.
Depending on the installation position, remove the
back panel of the fitted unit.
Preparing the appliance
WARNING ‒ Risk of injury!
The appliance is heavy.
▶
To move the appliance, two people are required.
▶
Use only suitable tools and equipment.
1.
Place the appliance on a soft surface and remove
the transport lock.
2.
Stick the sealing in the designated groove and
trim it .
3.
Screw the covering plate in tightly, depending on
the installation position.
Installing the appliance
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
▶
Wear protective gloves.
The appliance is heavy.
▶
To move the appliance, two people are required.
▶
Use only suitable tools and equipment.
Note:
To protect the cables, do not remove the trans-
port lock yet.
1.
Lift the appliance by the short sides and align the
front of the appliance with the hob.
