52
en
Technical specifications
Problem
Cause
Solution
Display shows
“Refill with still water
or remove filter”
Water tank wrongly inserted
Insert water tank correctly
Carbonated water in the water
tank.
Fill the water tank with fresh tap
water.
Float is stuck in the water
tank.
Remove the tank and clean
thoroughly.
New water filter not rinsed
according to instructions, or
water filter used or defective.
Rinse the water filter according to
the instructions and then switch
on, or use a new water filter.
Air in the water filter.
Dip the water filter into water
until no more air bubbles
escape, replace the filter.
Display shows
“
Empty drip trays
”
despite them being empty.
Drip tray is soiled and wet.
Clean and dry the drip tray
thoroughly.
Emptying is not detected
when the appliance is
switched off.
When the appliance is switched
on, remove and reinsert the
drip tray.
Display shows
“
Insert drip trays
”
even
though drip tray in use.
Inside of appliance
(tray holder) dirty.
Clean the inside.
The coffee grounds container
is not fully inserted.
Push the coffee grounds
container all the way in.
Water dripped onto the
inner floor of the appli
ance when the drip tray
was removed.
Drip tray was removed too
soon.
Wait a few seconds after the
last drink was dispensed before
removing the drip tray.
Display shows
“Switch off with power
switch, then back on after
30 sec!”
Appliance is too warm.
Leave the appliance to
cool down.
Dirty brewing unit.
Clean the brewing unit.
If you are unable to solve the problem, always call the hotline!
You will find the telephone numbers at the back of these instructions.
Technical specifications
Power connection (voltage – frequency)
220240 V – 50/60 Hz
Power rating
1600 W
Maximum static pump pressure
19 bar
Maximum water tank capacity (without filter)
2.4 l
Maximum capacity of the coffee bean container
500 g
Length of power cable
1.7 m
Dimensions (H x B x D)
455 x 495 x 375 mm
Weight, empty
1920 kg
Type of grinding unit
Ceramic
