Conettix DX4020
|
Installation Guide | 6.0 IP Address Programming
.
Bosch Security Systems, Inc. | 1/09 | F01U045288-05
13
17.
Press [Enter] after entering the correct number of
bits for the Netmask.
Table 5:
Netmask Addresses
Host Bits
Netmask
Host Bits
Netmask
1
255.255.255.254
17
255.254.0.0
2 255.255.255.252
18
255.252.0.0
3
255.255.255.248
19
255.248.0.0
4 255.255.255.240
20
255.240.0.0
5
255.255.255.224
21
255.224.0.0
6 255.255.255.192
22
255.192.0.0
7
255.255.255.128
23
255.128.0.0
8 255.255.255.0
24
255.0.0.0
9
255.255.254.0
25
254.0.0.0
10 255.255.252.0
26 252.0.0.0
11
255.255.248.0
27
248.0.0.0
12 255.255.240.0
28 240.0.0.0
13
255.255.224.0
29
224.0.0.0
14 255.255.192.0
30 192.0.0.0
15
255.255.128.0
31
128.0.0.0
16 255.255.0.0
When using DHCP, the following message
appears:
To assign a device name for use on a LAN,
type
Y
, enter up to 16 characters, and press
[Enter]. Otherwise, only press [Enter].
When using the DX4020 to communicate
to RPS over a network, enter a unique name
known to the person programming the
control panel.
If you do not enter a DHCP device name,
the default Cxxxxxx is used (where xxxxxx is
the last six digits of the MAC address).
18.
Change the Telnet password by pressing [Y] and
entering a password or press [Enter] to leave the
default telnet password.
This screen shows the Setup Mode screen you
previously saw.
Keep your password in a secure place. If
you forget or lose the password, you cannot
use Telnet again to configure the DX4020
until the DX4020 is returned to the factory
for reconditioning.
19.
Press [1] and [Enter] to access the setup Channel 1
configuration.
20.
Press [Enter] to accept 9600 as the default baud
rate. If 9600 is not the default, type
9600
and press
[Enter] to change it.
21.
Press [Enter] to accept 4C as the default I/F Mode.
If 4C is not the default, type
4c
and press [Enter] to
change it.
22.
Press [Enter] to accept 00 as the default flow. If 00
is not the default, type
00
and press [Enter] to
change it.
23.
Type a unique port number for the LAN the
device is connected to and press [Enter].
