Conettix DX4020
|
Installation Guide | 6.0 IP Address Programming
.
Bosch Security Systems, Inc. | 1/09 | F01U045288-05
11
6.5
Using Telnet to Complete
Configuration
Refer to
Section 6.5.1 Using Windows 98 Telnet
when
using Windows 98.
Refer to
Section 6.5.2 Using Windows 2000/XP Telnet
beginning on page 15 when using Windows 2000/XP.
6.5.1
Using Windows 98 Telnet
1.
At the Start Menu, select
Start
Æ
Run
to open a
DOS window.
2.
At the Run dialog box, type
telnet
and press
[Enter] to start the telnet application.
3.
Select
Connect
Æ
Remote System...
The Connect window opens.
4.
At the Host Name field, type the DX4020 IP
address assigned in the previous section.
In this example, the IP address is 172.17.10.70.
5.
At the Port field, type
1
and leave the TermType
field at
vt100
.
6.
Click
Connect
and wait a few seconds for the
following failed message to appear.
7.
Click
OK
to open the Telnet window again.
8.
Repeat
Step 3
in
Section 6.4.2 Using the ARP
Command
, on page 10.
9.
This time, leave all but the Port field the same.
Type
9999
in the Port field.
10.
Click
Connect
.
11.
Press [Enter].
If you do not press [Enter] within 5 sec of
seeing the “Press Enter to go into Setup
Mode” message, the system disconnects
you and the following message appears.
