AUTODOME IP starlight 7000i
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en
37
Bosch Security Systems
Installation Manual
2021-03 | 1.2 |
2
24 VAC Power (red)
6
Alarm Outputs (white)
3
Relay Contacts (yellow)
7
Alarm Inputs (gray)
4
Coax Video (black)
(Not applicable for AUTODOME
7000 Series cameras)
8
Serial Communications (green)
Used for Audio Input/Output in
AUTODOME 7000 Series.
i
Notice!
Connection, page 55 chapter for wire specifications and distances.
1.
Route all incoming wires through one of the earth-grounded conduits at the bottom of the
Mounting Plate. For a mast mount, route all wires through the right-angle conduit.
2.
Attach the water-tight plug to the other conduit.
3.
Attach the grounding spade terminal (item 1, below) to one of the spade terminals inside
the Mounting Plate.
Figure 9.11:
Mounting Plate - Inside Detail
Ref.
Description
1
Grounding lug with two spade terminals
2
Earth ground lug with crimp ring terminal
3
Wire input conduit holes
4.
Connect the incoming 24 VAC power wires to the 5-pin, 24 VAC Power In mating
connector (supplied with the Mounting Plate kit) for the camera and for the Heater.
Summary of Contents for AUTODOME IP starlight 7000i NDP?7512?Z30
Page 1: ...AUTODOME IP starlight 7000i NDP 7512 Z30 NDP 7512 Z30K en Installation Manual ...
Page 2: ......
Page 71: ......
