Bosch AUTODOME IP 4000i, Installation Manual

Page: 32 / 44

32 en | Installing a Surveillance Cabinet and Camera AUTODOME IP 4000i
2017.08 | 1.0 | F.01U.xxx.xxx Installation Manual Bosch Security Systems
12 Installing a Surveillance Cabinet and Camera
The surveillance cabinet can attach directly to a wall, to a corner mount, or to a pole mount.
To install the cabinet (power supply box), follow the instructions in the Surveillance Cabinet
Installation Manual .
1. Thread the cables through the wall and the mounts.
Ensure that the cables are long enough to reach through the mount and the camera’s
mounting cap to the connections from the camera.
12.1 Installing the Wall Mount
1. Slide the mounting flange over the wall mount.
2. Attach the wall mount to the mounting flange and fix them on the front door of the Wall-
mount Surveillance Cabinet by using four M5 screws.
12.2 Attaching the Camera to the Pendant Interface Plate
1. Install the pendant interface plate mount onto the end of the wall mount or the pipe
mount.
2. Attach an M5 screw and the L-shaped end of the safety tether to the stand-off on the
pendant interface plate mount with the T25 Torx screwdriver.
3. Attach the M4 screw to the ground point on the pendant interface plate mount with the
T25 Torx screwdriver.
M4
T25
T25
M5
4. Route the cables from the ceiling out of the side of the mounting plate with the crescent-
shaped cut-out.
5. Attach the metal mounting plate to the inside of the pendant interface plate mount with
the three (3) M4 screws. Orient the plate as indicated in the following figure.