Bosch AUTODOME IP 4000 HD NEZ-4 series, Installation Manual

Page: 28 / 38

Connection
!
Warning!
Bosch’s version of PoE+
If supplying power to the camera by PoE+ or by a midspan device, you must install additional
surge protection.
!
Warning!
Bosch’s version of High PoE:
If supplying power to the camera by HPoE or a midspan device, you must install additional
surge protection.
!
Caution!
Compliance with EN50130-4 Alarm Standard – CCTV for Security Applications
To meet the requirements of the EN50130-4 Alarm Standard, an ancillary uninterruptable
power (UPS) supply is necessary. The UPS must have a Transfer Time between 2–6 ms and a
Backup Runtime of greater than 5 seconds for the power level as specified on the product
datasheet.
Note: Consult the National Electrical Code (NEC) for cable bundling requirements and
limitations.
4
Connect the cable to the 24 VAC wires from the camera.
Label ID Description Cable Wire Color
AC24V 24 VAC Red
AC24V 24 VAC Black
EARTH Earth Ground Yellow/Green
4
Connect the Ethernet cable to the RJ45 connector of the camera. The following figure
illustrates a typical system configuration.
9
28 en | Connection AUTODOME IP 4000 HD
2015.03 | 0.1 | Installation Manual Bosch Security Systems