Bosch AUTODOME IP 4000 HD NEZ-4 series, Installation Manual

Page: 23 / 38

Wall Mount Installation Instructions
!
Caution!
Strength of Mounting Surface
The fasteners and mounting surface must be capable of supporting a maximum load of
12 kg (26.4 pounds).
1.
Locate a secure position to secure the Wall Mount Base (1). Ensure there is an adequate
opening in the wall for the wires to pass through.
2. Use the Rubber Gasket as a template to mark the locations of the four wall plugs and
screws.
3. Insert the wall plugs (if necessary) into the wall at the locations marked in step 2.
4. Place the rubber pad between the Wall Mount Base (1) and the wall. Secure the Wall
Mount to the structure with the four (4) M10x25L screws and washers (3).
5. Apply Teflon tape to the threads on the Wall Mount Base.
6. Apply Silicon grease over the Teflon tape on the threads of the Wall Mount Base. Ensure
the grease is spread evenly.
7. Fasten the Adaptor (5) to the end of the Wall Mount.
8. Thread all connection cables through the Wall Mount.
1. Attach the hook at the end of the Safety Tether (4) to the loop attached to the top of the
camera (6).
2. Connect all cables to the camera back plate.
3. Place the top of the camera (6) inside the Adaptor (5) and turn clockwise until the
camera latches to the adaptor.
4. Fasten the M5x8L screw using the T20 Security Torx wrench (shipped with the camera)
to secure the camera to the adaptor.
AUTODOME IP 4000 HD Install a Wall Mount and Camera | en 23
Bosch Security Systems Installation Manual 2015.03 | 0.1 |