AMC2 4W
Introduction | en
15
Bosch Security Systems
Installation manual
F.01U.024.965 | V.4 | 2006.09
3.2
Equipment Configuration
Fig. 3.3
Upper circuit board with display (top side)
1.
Internal tamper contact
2.
DIL switch for RS-485 address selection, protocol and RS-
232/RS-485 selection
3.
Lithium battery for buffering of static RAM and real time
clock (RTC). The battery shall be replaced by qualified per-
sonnel every ten years or if indicated by an appropriate
event.
4.
Reset push button - available by using the srew driver
5.
LC Display
6.
Push button to select the display view - available by using
the push button on the top of the housing
7.
Jumper: Potential equalization between different mass sys-
tems and protective earth (shield)
8.
Jumper: interface selector RS-485 Host connection, RS-
485 two wire or RS-485 four wire (depends on external
wiring)
9.
Configurable RS-485 host interface (pluggable screw con-
nector)
10. Docking station for the compact flash
