8
| English
F 016 L70 916 | (26.6.12)
Bosch Power Tools
Intended Use
This multi-tool attachment can only be operated by the power
unit AMW 10.
The machine is intended for cutting and trimming hedges and
bushes in domestic use.
Technical Data
Declaration of Conformity
We declare under our sole responsibility that the product de-
scribed under “Technical data” is in conformity with the fol-
lowing standards or standardization documents: EN 60335
according to the provisions of the directives 2006/95/EC,
2004/108/EC, 2006/42/EC, 2000/14/EC.
2000/14/EC: Guaranteed sound power level 103 dB(A).
Equipment category: 25
Technical file (2006/42/EC) at:
Bosch Lawn and Garden Ltd., PT-LG/ENS,
Stowmarket, Suffolk IP14 1EY, England
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
22.05.2012
Noise/Vibration Information
The following information is applicable for the attachment op-
erated by the power unit:
Measured sound values determined according to
EN ISO 10517.
Typically the A-weighted noise levels of the product are:
Sound pressure level 80,5 dB(A); sound power level
100.5 dB(A). Uncertainty K =2.5 dB.
Vibration total values (triax vector sum): Vibration emission
value a
h
= 2.5 m/s
2
, Uncertainty K= 1 dB.
Mounting and Operation
Troubleshooting
Symbol
Meaning
Wear protective gloves
Wear eye protection.
Reaction direction
Movement direction
Pole Hedgecutter Attachment
AMW HS
Article number
0 600 8A3 A..
Cutting length
mm
430
Tooth opening
mm
15
Weight according to
EPTA-Procedure 01/2003
without power unit
kg
2.25
Serial number
see type plate on the gar-
den product
Please observe the article number on the type plate of your garden prod-
uct. The trade names of the individual garden products may vary.
Dr. Egbert Schneider
Senior Vice President
Engineering
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
Action
Figure
Delivery Scope
1
Turn and fix blade in operating position
2
Fitting the multi-tool attachmentt
3
Set operating angle
4
Working Advice
5
Storage
6
Problem
Possible Cause
Corrective Action
Motor runs but blades re-
main stationary
Multitool-attachment not properly connected to
power unit
Check for correct assembly
Cutting blade hot
Cutting blade blunt
Have blade sharpened
Cutting blade has dents
Have blade inspected/overhauled
Too much friction, due to lack of lubricant
Apply lubricant spray (1 609 200 399)
OBJ_DOKU-30999-001.fm Page 8 Tuesday, June 26, 2012 8:09 AM