28
en | Installing
AMC2 4W | Installation manual
F.01U.024.965 | V 0.1 | 2006.03
Bosch Sicherheitssysteme GmbH
5.3
Opening the AMC2 4W Case
The AMC2 4W case consists of a top cover mounted with a two-
point snap-in closure on a ground chassis. To open the
AMC2 4W push down the two snap-ins with a srew driver. After
that the cover can be moved to bottom.
Fig. 5.3
Opening the AMC2 4W case
5.4
Cabling
i
NOTE!
To open the AMC2 4W, first, remove all pluggable screw con-
nectors at least the host connection.
CAUTION!
The cables used in the AMC2 4W access control system are not
prone to electrical interference. However, you should avoid
routing cables close to heavy load switching cables and equip-
ment. If this is unavoidable, cross the cable at right angles every
1 to 2 m (3 to 6 ft) to reduce interference.