LTC 2600 Series
| Instruction Manual
|
Multiplexer Set (MS) Commands
Bosch Security Systems | July 12, 2004
EN
| 25
MS-VCR-RELAY
<vcr> <responds to> <polarity>
This command sets the response and polarity for the
relay connected to the VCR attached to the specified
monitor.
Parameter values for <vcr >, <responds to>, and
<polarity> are as follows:
<vcr>
1
VCR output
2
VCR/Monitor B output
<responds to>
0
Neither
1
Action
2 Alarm
3 Both
<polarity>
0
Normally open
1
Normally closed
MS-VCR-TEST
<boolean>
This command turns ON/OFF the VCR test mode. If
ON, monitor A goes to full screen, and the data being
received from the VCR is displayed on monitor A.
Parameter values are <0> for OFF, <1> for ON.
MS-VCR-TIMELAPSE
<vcr> <timelapse-mode>
<vcr-mode>
This command sets the timelapse mode for the VCR
attached to the <vcr>…
NOTE to NHU-this description in the new CCL
document is very confusing -- can we rewrite it?
Parameter values for <vcr >, <timelapse-mode>, and
<vcr-mode> are as follows:
<vcr>
1
VCR output
2
VCR/Monitor B output
<timelapse-mode>1
Normal
2
Action/Alarm
<vcr-mode>
1 to 20
MS-VCR-TITLE
<custom-vcr-model#> <text >
This command assigns a title to the custom VCR
definition designated by <custom-vcr-model#>.
Parameter values are as follows:
<custom-vcr-model#>
1 to 6 (corresponding to
custom VCR setting 1 to 6)
<text>
(Use acceptable
alpha/numeric characters-see
Appendix A; only the first 12
characters of <text> will be
used.)
MS-VCR-VEXT
<vcr>
This command enables or disables VEXT input for the
VCR.
Parameter values for <vcr > and <boolean> are as
follows:
<vcr>
1
VCR output
2
VCR/Monitor B output
<boolean>
0
Disables VEXT
1
Enables VEXT
MS-VIDEOLOSS-OUT
<polarity>
This command sets the output polarity for the VCR's
videoloss relay.
Parameter values for <polarity> are:
0
Normally open
1
Normally closed
MS-VIDEOLOSS-OUT-ENABLE
<boolean>
This command enables or disables the videoloss relay
output.
Parameter values for <boolean> are:
0
Disables videoloss relay
output
1
Enables videoloss relay
output
