LTC 2600 Series
| Instruction Manual
|
Multiplexer Set (MS) Commands
Bosch Security Systems | July 12, 2004
EN
| 16
MS-LOG-SETUP
<boolean> <boolean> <boolean>
<boolean> <boolean>
This command enables of disables logging of the
following: action, alarms, videoloss, events, and errors
(respectively).
Parameter values are:
0
Disabled
1
Enabled
MS-MON-A-DISPLAY
<mode> <camera list>
This command allows you to select the
display
mode
for monitor A, as well as the cameras to be displayed
in the specified mode.
Parameter values for <mode> and <camera list> are:
<mode>
0
Full Screen
1
Single Quad
2
3 x 3 Multi
3
4 + 3 Multi
4
12 + 1 Multi
5
4 x 4 Multi
6
8 + 2 Multi
NOTE: Selecting
Quad
mode will loop between
available quad modes. For non-duplex, System4 units,
only
Full Screen
mode will be accepted for monitor B.
<camera list> A list of camera numbers (values 1 to
16), up to 16 numbers (one for every cameo in the
screen mode selected). The order depends on the
screen mode selected (i.e. how cameos are arranged
in the screen).
EXAMPLE:
3 x 3 Mode Display
To view the above screen layout on monitor A, enter a
value of <2> for the mode and a value of <5 6 7 1 2 3
12 13 14> for the camera list. The position of a camera
in the camera list determines in which cameo the
camera will be displayed. The number of items in the
required camera list varies based on the
display
mode
selected.
SCREEN MODES AND SCREEN SEGMENT
NUMBERING
The numbers shown inside the cameos indicate the
position of that cameo in the camera list
ADDITIONAL NOTES ABOUT THE MS-MON-A-
DISPLAY COMMAND
•
The source of the video being viewed and the
display
mode available will be determined by the
current operating mode (e.g. encode, decode, live)
of the multiplexer.
•
Whenever a camera is specified for a cameo, the
zoom, freeze, and sequencing modes in that cameo
are turned off.
•
If no camera list is sent, the current camera list for
the specified
display
mode will be used. This allows
display
mode selection while retaining the current
camera selections and zoom/sequence settings (as
applicable).
•
If a camera list length is less than the number
required to completely specify all the cameos, the
current camera list for that
display
mode will be
used for the unspecified cameras. This allows
display
mode selection and partial camera selection
changes, while retaining some of the camera
selections and sequence settings (as applicable).
•
If a camera list length is more than the number
required to completely specify all the cameos, the
extra cameras settings are ignored, without an error
message. This allows a previously selected
prioritized camera list to be to the extent of the
display
mode selected.
•
When the
MS-MON-A-DISPLAY
command is
sent, the front panel keyboard will be allocated to
MON A, and the MON B LED will go off (if the
keyboard was previously allocated to MON B).
Camera 1 will be selected as the active camera.
•
Delay slightly when sending multiple
MS-MON-A-
DISPLAY
,
MS-OPERATION-SIMPLEX
,
MS-
OPERATION-DUPLEX
commands (about .1 sec)
to avoid getting an error message stating that the
multiplexer keyboard is busy (it may be busy
processing one of the above commands previously
sent).
5
6
7
1
2
3
12
13
14
