Bort 93720100, User Manual

Page: 8 / 26

8
To prevent damage during transport, the appliance is
delivered in a solid packaging which consists largely of
reusable material.Therefore please make use of options
for recycling the packaging.
Problems Causes Possible solutions
The machine does not
start
The machine is not plugged in Connect the machine to a suitable outlet
Defective plug
Change the plug or have your electrical
installation inspected
The fuse is blown Change the fuse with a similar one
Fluctuations of
pressure
The pump sucks the air Check that hoses and fittings are waterproof.
Dirty, worn or jammed Contact your service center
The water supply is not enough
Increase the water pressure, check for blockage
of the hose and / or change the large hose.
Worn out pump seals The machine stops. The fuse is blown
The fuse is blown
Too small fuse Replace with a higher fuse.
Increase the amperage Try without the extension cable
The machine stops
The fuse is blown Replace the fuse.
Mains voltage incorrect Disconnect the other machines.
Thermal sensor activated
Check that the mains voltage corresponds to the
specification on the nameplate
The fuse is blown
Too small fuse
Replace with a higher fuse.
Try without the extension cable
Increase the amperage
Pulsation of the
machine
Air in the inlet hose / pump
Let the machine operate with the open trigger
until the working pressure resumes regularly.
Inadequate supply
Increase the water pressure, check for blockage
of the hose or change the large hose
Jet is partially blocked
Clean the jet with a needle and spray some water
toward the rear through the jet
Blocked water filter Clean the filter
Hose bending Straighten the hose.
The machine starts and
stops automatically
Leaky shotgun and/or trigger Contact your nearest service center
The machine starts, but
the water does not come
out
No water supply Connect the water inlet.
Blocked water filter Clean the filter
Blocked jet
Clean the jet with a needle and spray some water
toward the rear through the jet