12
ON/OFF switch
1. To switch on, slide button (1) forwards and let it engage. The appliance will now run
continuously until you switch it off.
2.
To switch off , simply press the rear part of button (1) it jumps back into
its
”
Off
”
position .
Cutting operation
·
Mark the cutting line and its centre on the workpiece.
·
Clamp the workpiece on a flat surface to ensure it will not move during operation.
·
Adjust the moving fence, cutting depth and cutting angle according to your needs.
·
Place your product on the workpiece, the marking on the workpiece facing the
marking on the moving fence (if applicable). Make sure that the disc cutter does not yet
touch the surface.
·
Switch the product on and wait until it runs at full speed before cutting into the
workpiece.
·
Push the product slowly forward at an even speed until the desired depth is reached.
·
Pull the product backward from the workpiece before switching it off.
Only apply as much pressure as necessary to keep the product flat on the
workpiece. Higher pressure will not increase but lower the performance of
the product and leads to uneven results.
Changing the cutter
Danger of injury !
Never adjust the appliance when the mains plug is in the socket.
