BorMann 043102, User Manual, Page: 7 / 27

EN
WWW.BORMANNTOOLS.COM
7
Setting the table square to saw blade
Tools Required : Small 90 º square (not supplied).
The table can be set at 90º to the sawblade by adjusting the table stop
screw underneath the table. See Fig. 12.
FIG. 12
FIG. 13
FIG. 14
FIG. 15
Refer to Figure 13:
Loosen the nut (A, Fig 13), adjust bolt (B).
Checking the table for flatness
A steel rule should be held on the table across the table slot
close to the front edge of the table. (See Fig. 14)
If the straight edge shows there is a step across the tables lot then
the table needs to be adjusted using the two screws and locking nuts
provided for this purpose, located on the underside of the rip fence
guide, at (D, Fig 14).
Lower blade guard
When open the lower bandwheel door on this machine the lower
blade guard (Fig 15).
The bandwheel doors MUST be closed at all times when the machine
is being operated.
Mains connection
Mains connection and any extension cords used must comply with ap -
plicable regulations. The mains voltage must comply with the informa -
tion on themachine licence plate. The mains connection must have a
10 A surge-proof fuse. Only use power cords marked H07RN-F
Connections and repairs to the electrical equipment may only be car -
ried out by qualified electricians.
Dust connection
The machine is equipped with a dust port dia 100mm (B, Fig. 16).The
dust port is located at the back of the band saw for mounting a hose
(not provided) to connect a dust collector or shop vacuum.
Before initial operation, the machine must be connected to a dust ex -
tractor. The suction should switch on automatically when the bandsaw
is switched on. T
The flow rate on the suction port must be 20m/sec. Flexible hoses must
be of non-flammable quality, and must be connected to the machine
ground system.
Starting operation
Magnetic(ON/OFF) Switch – located on front of machine: You can start
the machine with the green on button. The red button on the main
switch stops the machine.
Work Lamp Switch – located on front of machine above ON/OFF
switch. Turns LED work lamp on and off.