BorMann 043102, User Manual, Page: 6 / 27

EN
WWW.BORMANNTOOLS.COM
6
Fitting the table
Fitting guide rail fence
Refer to Figure 8.
Loosen lock handle (shown in Figure 9) and pivot trunnion (A1) to
horizontal position. Loosen lock knob (C2) and pull extension (C1) out
from the table (C). Orient table as shown, then maneuver to allow saw
blade (A2) to pass through slot (C3) to the center. Line up four thread -
ed mounting holes underneath table with the four mounting through-
holes on trunnion.
Important : Adjust table so miter slot (C4) is parallel with saw blade
(A2). Secure with four M6x12 hex washer head screws (HP2). Tighten
with 13mm wrench.
Refer to Figure 9.
Attach guide rail (Eww) to front of table. Secure with four wing screws
(HP4) and flat washers (HP5).
FIG. 8
FIG. 9
FIG. 10
Refer to Figure 10.
Place fence assembly (D, Figure 10) onto table at the miter slot.The
rear hook should engage the rear of the table. The fence body should
engage the guide rail (E). If the fence is not parallel to the miter slot:
Loosen two socket head cap screws (S1) with a 4mm hex wrench. End
cap (S2) may need to be removed. Adjust fence so it is parallel to miter
slot. Lock the fence handle, securing it to the guide rail (E), and verify
that fence is still parallel to miter slot. Retighten two screws (S1) to
secure fence to the fence body and replace end cap (S2).
Install quick-tension handle into hub on back of saw. (see Q, Figure 11),
and tighten using a wrench on the flat of the shaft.
Fence scale adjustment (refer to Figure 10)
Place fence assembly (D) onto table (C) against the saw blade. Lock
fence.If the hairline on the scale indicator does not point to zero:
Remove fence assembly (D).Loosen screw (S3) that secures scale to
guide rail (E).
Repeat step 1, then slide scale until hairline on scale indicator points
to zero.
Being careful not to move the scale, unlock and lift fence from the ta -
ble.Tighten screw (S3) to secure scale in position.
If further adjustment is needed, wing screws (HP4) can be loosened to
allow adjustment of guide rail (E).
Quick tension handle (refer to Figure 12)
FIG. 11