BorMann 043102, User Manual, Page: 5 / 27

EN
WWW.BORMANNTOOLS.COM
5
Hardware Package
3
4
32
4
4
6
3
3
32
Hex cap screw M8x55 - HP1
Hew washer head screw
Carriage bolt, M6X12 - HP3
Wing screw - HP4
Flat washer blk oxide M8 - HP5
Flat washer M8 - HP6
Lock washer M8 - HP7
Hex nut M8 - HP8
Hex flange nut, M6 - HP9
FIG. 4
IV. Transport and start up
Transport and installation : For transport use a forklift or hand trolley. Make sure the machine does not tip or fall off during transport. The
machine is designed to operate in closed rooms and must be placed stable on firm and levelled ground.
Stability of bandsaw: Before using the bandsaw, ensure the machines upright stability is satisfactory. The bandsaw has three Ø8mm holes
(A, Fig 5 Fig.6 Fig.7) in it’s base to allow it to be bolted to a workbench or to the supplied open stand. For packing reasons the machine is not
completely assembled.
Refer to Figure 6,Figure 7 to assemble stand. Use carriage bolts (HP3) and flange nuts (HP9) throughout. Only hand tighten all fasteners at this
time. Make sure the two short support plates with extra holes (M) are opposite one another as shown. Slip rubber feet (L) onto ends of stand
legs.Place stand upright on level floor, and push down until it sits evenly.Tighten all nuts on stand assembly.
FIG. 5
FIG. 6
FIG. 7