EN
WWW.BORMANNTOOLS.COM
16
Mitre angle indicator adjustment
1. Loosen screw (79) approx. one turn.
2. Adjust pointer (78) until the indicated value corresponds with the current
stop position of the rotating table.
3. Tighten screw (79).
(i) Note:
The rotating table engages in positive stops at the 0°, 15°, 22.5°, 31.6°, 45°, and
60° position.
Bevel tilt positive stop adjustment
1. Engage track arm holder (80) at the 0° position; do not tighten locking lever
(81).
2. Loosen the two pin screws (82) at the rear of the saw by approx. one turn.
3. Adjust the track arm holder until the saw bladeis at exactly 90° against the
rotating table.
4. Tighten the two pin screws (82) at the rear of the saw again.
5. Tighten locking lever (81).
6. Loosen screw (84) approx. one turn.
7. Adjust pointer (83) until the indicated value corresponds with the current
stop position of the track arm holder.
8. Tighten screw (84).
Note:
The track arm holder engages in positive stops at the 0°, 22.5° 33.9°, and 45°
XXXIII.
XXXIX.
XXXV.
XXXVI.
Summary of Contents for 037590
