BORETTI CFBG901 Series, Instruction On Mounting And Use Manual

Page: 238 / 240

238
CONNECTION OF THE POWER SUPPLY CABLE
WARNING: If the power supply cable is damaged, it must be replaced only by an
authorised service agent in order to avoid a hazard.
• Unhook the terminal board cover by inserting a screwdriver into the two hooks “ A ”
(fig. 9.1).
• Open the cable gland by unscrewing screw “ F ” (fig. 9.2), unscrew the terminal
screws.
• Insert the feeder cable of the suitable section (as described in the next chapter)
into the cable gland.
• Connect the phase and earth cables to the terminal block according to the diagram
in figure 9.3.
• Pull the feeder cable and block it with cable gland.
• Close the terminal block cover (check the two hooks “ A ” are correctly hooked).
IMPORTANT: To connect the power supply cable DO NOT unscrew the screws
fixing the cover plate behind the terminal block.
N.B. The earth conductor must be left about 3 cm longer than the others.
FEEDER CABLE SECTION Type “H05RR-F”
220-240 V ac 3 x 1,5 mm
2
(*)
(*) – Connection possible with plug and outlet
F
Fig. 9.2
230 V
PE
N L
Fig. 9.3
220-240 ac
Fig. 9.1
A