![background image](http://html.mh-extra.com/html/boretti/btg-100/btg-100_operating-instructions-manual_2788376082.webp)
82
Turning off all burners
To turn off all burners simultaneously, briefl y press the ON/OFF button: the appliance will enter
standby mode.
Setting the clock
After a power failure, the hob clock must be
reset.
To set the clock, simultaneously press and
hold the buttons shown in the fi gure for at
least 3 seconds. The fl ashing digits on the
left of the dot indicate the hour and the digits
on the right indicate the minutes. Increase or
decrease the hour using the “+” and “-” buttons.
Hold down the “+” or “-” button to increase or decrease the hours digits rapidly.
To set the minutes, press the button with the clock symbol again. The digits on the right of the dot
will start fl ashing; set the minutes as described above. Press the button with the clock symbol
again to save the set time.
Burner reset
The burners may lock out due to external faults (for example, in the event of either a power or
gas supply failure).
The display of each locked out burner will show the letter “b”. To reset the burners, simultaneously
hold down the
the most left
“-” and “key” buttons as shown in the fi gure for at least 2 seconds.
Once the burners have been reset, they will be set to level 0, ready to be turned on again.
N.B.: If you repeat the reset procedure 5 consecutive times within 15 minutes, the message
FLT06 will be displayed and no other reset requests will be accepted for the following 15 minu-
tes.
Touch panel lock
To activate this function, press the “key” button for
at least 2 seconds. All burner power levels will re-
main in their current status. When the touch panel
is locked the decimal points light up in the display of
each burner. When the touch panel is locked, it is not
possible to change the burner power levels or change
the timer settings, but it is possible to switch the hob
off by pressing the ON/OFF button. Locked burners cannot be reset when the touch panel lock is
activated. The touch panel must be unlocked before performing the burner reset procedure.