11
If you connect the 2 buckets with a hose then the bucket with
higher water level will try to fill the bucket with the lower water
level until they are equal. It is the same with batteries and this is
why we should always use the same battery type and cell count
when connecting the outputs of Wallaby Switch together.
Using Wallaby Switch with a Booma RC DUAL-BAT circuit.
The Dual-Bat circuit allows you to safely connect the 2 Wallaby
Switch outputs together, effectively isolating the batteries from
each other. In a single receiver setup a Dual Bat circuit is a great
idea. The Wallaby Switch internal microprocessor circuit uses an
internal micro Dual Bat circuit to guarantee supply to the Wallaby
Switch microprocessors.
Battery Capacity
DO NOT EVER
try to get the full mA capacity out of your batteries!
An attempt to do this may end in disaster. Wallaby Switch meters
consumption conservatively but
NEVER OPERATE YOUR MODEL
WITH A LOW VOLTAGE CONDITION.
Current carrying capacity of connectors.
Wallaby Switch will handle 15A per circuit (30A total). However,
JR or Futaba type servo connectors are designed to carry a maxi
-
mum of approximately 5 Amps per connector. This is sufficient
for most RC models up to 9 servos. If your model has more than
9 servos it is recommended to use a deans style ultra connector.
