Bonn CM-1401T, Owner'S Manual

Page: 7 / 13

5
20sec Button
This function allows for instant heating at 20 second
increments at Hi power.
By repeatedly touching the 20sec button, heating time of up to
5 minutes at full power can be chosen.
1. Open the door and place food in the oven. Close the door.
• “HELLO” will show on the display.
2. Press 20sec button.
•
Press 20sec button, “ :20” shows in the display.
• The oven will start immediately. To increase heating
time by 20 seconds press 20sec button again. Up to 5
minutes heating time can be selected.
NOTE
The cooling fan will continue to run for 60 seconds to cool the oven down
after operation.
1. Open the door.
• Display turns o
ff .
2. Press and hold STOP button for 5 seconds.
•
When the oven enters Oven Options mode, “CODE---”
will be displayed.
3. Enter the two digit code to activate the desired option.
For example, to turn o
ff touch pad beeping, press 2
followed by 1.
4. Press START to save changes.
•
To make further changes repeat steps 3 and 4.
Oven Options
Function Code Description (Factory default setting in bold)
Changing Heating
Completion Sound
CODE 1-0 3 long beeps for 3 seconds
CODE 1-1 1 short, 1 long beeps for 3 seconds
CODE 1-2 3 second beep
CODE 1-3 3 quick beeps for 3 seconds
CODE 1-4 5 quick beeps for 3 seconds
Turning O ff
Touch Pad Beep
CODE 2-0 Touch pad beeps when pressed.
CODE 2-1 No beep when button is pressed.
Turning O ff Multi Stage
Noti fi cation Beep
CODE 3-0 The oven will beep when multi stage heat changes to the next stage.
CODE 3-1 No beep when multi stage heating changes to the next stage.
Adjusting Maximum
Possible Heating Time
CODE 4-0 Maximum Heating Time is 60 minutes.
CODE 4-1 Maximum Heating Time is 10 minutes.
Changing Number Of
Preprogrammed Heating Choices
CODE 5-0 10 preprogrammed settings available (0~9)
CODE 5-1 200 preprogrammed setting available (0~199)
Adjusting Standby
Activation Time
CODE 6-0 Display will turn o ff after 1 minute.
CODE 6-1 Display will turn o ff after 2 minutes.
CODE 6-2 Display will turn o ff after 3 minutes.
CODE 6-3 Display will turn o ff after 4 minutes.
Repeat Function
CODE 7-0 Repeat function deactivated.
CODE 7-1 Repeat function activated.
Activating Heating Completion
Message
CODE 8-0 No END message after fi nishing heating cycle.
CODE 8-1 Activation of “END” message after heating cycle.
Deactivating Manual
Oven Operation
CODE 9-0 The user may use preprogrammed buttons and manual time heating.
CODE 9-1 The user may use preprogrammed buttons only.
Clean Air Filter
Reminder
CODE 0-0 Clean fi lter message will show up for 24 hours every 90 days.
CODE 0-1 Clean fi lter message will show up for 24 hours every 60 days.
CODE 0-2 Clean fi lter message will show up for 24 hours every 30 days.
CODE 0-3 Clean fi lter message will show up for 24 hours every 10 days.
CODE 0-4 The oven will not display clean fi lter message.
Changing Oven Options
Oven Options can be changed to suit individual preferences
according to the options table below.