Bonn CM-1401T, Owner'S Manual

Page: 5 / 13

3
1 MICROWAVE indicator
Lights when the microwave is in
operation.
2 MULTI STAGE indicator
Indicates which STAGE of mult-stage
heating is in progress
3 CLEAN FILTER indicator
Will display when the fi lter needs
cleaning.
4
POWER LEVEL indicator
It will turn on when button is
pressed unless at full power.
5
button
button is used to change
power level.
6 Number buttons (1-0)
Number buttons are used to enter
heating time and start preprogrammed
heating cycles.
7 STOP button
Stops and Clears heating cycle.
Also deletes changes made to
programming.
8 START/20sec button
The START button is used to start a
manual heating cycle.
It is also used to save any changes
to programming sequences or user
options.
The START/20sec button can also be
used as an instant heating button. In
Standby mode, the 20sec button o
ff ers
instant heating of 20 seconds at full
power.
By repeatedly pushing the 20sec
button, up to 5 minutes at 20 second
increments can be selected. Power
level is Hi.
Control Panel
Wattage output chart
• The power level can be changed by touching the button. The chart below provides
the power level choices and the percentage of power these relate to.
Power Level (Display) Approximate Percentage of Power
HI 100%
70% 70%
50% 50%
20% 20%
00% 0%
1 2 3 4 7 6 5 8
Manual Heating
To heat food manually using a speci fi c heating time and
power level.
1.
Open the door and place food in the oven. Close the door.
• “HELLO” will show in the display.
2. Press button.
• When “HI” shows in the display, the power level is
full power.
• The % indicator will light if a lower power level is
selected.
• Power levels can be adjusted by pressing button
repeatedly.
3. Use number buttons 1-0 to enter desired heating time.
• Default maximum heating time is 60 minutes.
• To reduce maximum heating time to 10 minutes, see
Oven Options on page 5 in this manual.
4. If Multi Stage heating is desired, repeat steps 2 and 3.
• The display will indicate the stage being entered.
• Up to three di ff erent stages are possible.
5. Press START button.
• The oven lamp will turn on and heating will start.
• The STAGE indicator will start to blink and heating time
will count down.
NOTE
Repeat Function: The user can repeat exactly the same heating time and
power level by pressing the START button again before the oven goes into
standby mode (60secs). See Oven Options on page 5 to activate this function.
NOTE
The cooling fan will continue to run for 60 seconds to cool the oven down
after operation.