Bonn CM-1401T, Owner'S Manual

Page: 6 / 13

4
Preprogrammed Heating
To heat food using preprogrammed number buttons.
1. Open the door and place food in the oven. Close the door.
• “HELLO” will show in the display.
2. Press the desired number button.
• Press desired preset program from 1-0.
3. Oven heating cycle starts immediately.
• The oven lamp will turn on and heating will start.
• The STAGE indicator will start to blink and heating time
will count down.
NOTE
To increase the maximum number of programmable presets from 10 to 200,
see Oven Options on page 5.
Default factory settings supplied with oven
Button Heating time Power Level
1 10 sec. 100%
2 20 sec. 100%
3 30 sec. 100%
4 45 sec. 100%
5 1 min. 100%
6 1 min. 30 sec. 100%
7 2 min. 100%
8 3 min. 100%
9 4 min. 100%
0 5 min. 100%
NOTE
The cooling fan will continue to run for 60 seconds to cool the oven down
after operation.
Changing Preprogrammed
Button Settings
1. Open the door.
• Display turns o ff .
2. Press and hold button for 5 seconds.
• When the oven enters Programming mode, “PROGRAM”
will show in the display.
3. Select the number button to be programmed (1-0).
•
The display will show the program number selected.
(See note below.)
4. Press button to select desired power level.
•
If “HI” shows in the display, the power level is set to
full power.
• The % indicator will light if a lower power level is
selected.
• Power levels can be adjusted by pressing button
repeatedly.
5. Using number buttons 1-0 enter the heating time.
6. If Multi Stage heating is desired, repeat steps 4 and 5.
• The display will indicate the stage being entered.
• Up to three di ff erent stages can be programmed.
7. Press START to save the program changes.
• To discard changes, press STOP button.
NOTE
To increase the maximum number of programmable presets from 10 to 200,
see Oven Options on page 5.