2
3.
Notes for installation and use
For safety, make sure to observe the following matters.
This machine is designed with ground specification. For safety, be sure to use a
grounded electrical outlet.
If you do not have such outlet, install it separately.
Do not place where the machine would be exposed such as too much moisture,
direct sunshine, much dust and vibration.
Be sure to pull out the power plug when the machine is not used.
Be sure to grab the power plug when plugging or unplugging.
Please check your using voltage before use.
Before adjustment and cleaning of V-blade, Guide pulley and so on, be sure to
turn the power off and pull out the power plug from the electrical outlet.
Do not use the machine for purpose other than the original purpose.
Never touch V-blade during the operation.
Please use single-core solder wire in order to obtain sufficient effect.
Be sure to make V-groove just before the soldering work in order to obtain
sufficient effect.
This machine is designed for micro fine solder wire exclusive use. Strong shock
or rough handling may cause setting and adjustment trouble and reduction of
the effect.
Default of adjustment lever setting is DIA.0.6 mm when no request at
ordering.
