7
(D) Cleaning
Make sure to turn off the power switch and pull out the plug when cleaning.
(A)
V-blade
Remove the protection cover
from the machine.
Remove solder residues or
flux residues sticking to the
blade
In order not to damage the
blade, we suggest to use a
cotton swab soaked with
flux solvent like alcohol.
(B)
Guide pulley
Remove solder residues or
flux residues sticking to the
groove. Those accumulated
residues damage the V-blade. They reduce the performance of this machine,
such as prevention of solder ball scattering and so on.
Do not touch the V-blade in cleaning.
(C)
Wire guide nozzle
Remove the wire guide nozzle from the machine with a 1.5 mm hexangular wrench, and
clean inside of the nozzle.
※
a 1.5 mm hexangular wrench is NOT contained in the unit.
We suggest to use an air blower since inner diameter of this nozzle is very thin.
Do not crack or bend the edge of the nozzle.
(D)
Cleaner pin
Remove solder residues or flux residues sticking to the pin.
Do not touch the V-blade in cleaning.
(D)
(A)
(C)
(B)
